RTTY
[Top] [All Lists]

Re: [RTTY] Question

To: "'DickT-W0RAA'" <dickt@w0raa.com>, "'FT-950 Reflector'" <FT-950@yahoogroups.com>, "'Rtty Contesting Reflector'" <rtty@contesting.com>, "'Writelog Reflector'" <writelog@contesting.com>
Subject: Re: [RTTY] Question
From: "Russ Guidry SR" <rjguidrysr@verizon.net>
Reply-to: rjguidrysr@verizon.net
Date: Sun, 09 Jun 2013 12:10:00 -0700
List-post: <rtty@contesting.com">mailto:rtty@contesting.com>
Had same problem, MMTTY lost it FSK config.

Russ, K5OA

-----Original Message-----
From: RTTY [mailto:rtty-bounces@contesting.com] On Behalf Of DickT-W0RAA
Sent: Sunday, June 09, 2013 11:04
To: FT-950 Reflector; Rtty Contesting Reflector; Writelog Reflector
Subject: [RTTY] Question

I am using a Yaesu FT-950 with a SignaLink USB Interface.  Up until this
weekend, it has performed flawlessly in RTTY mode.  I usuall run PKT | LSB
when running in digital modes and have never had a problem.

Now, I cannot get the 950 to send out a signal when I send a macro using my
Writelog program (latest version).  I am not getting any RTTY output using
MMTTY either.

It shows that I am transmitting, but there is no signal going out.  Zero
power out.  In all other modes I ama getting full
100 watts
power out (SSB/CW, etc).

I have not changed anythinh since the last contest,  Might anybody have any
suggestions as to where I should be looking?  The problem is only in RTTY
mode.

TIA<

Dick
W0RAA

_______________________________________________
RTTY mailing list
RTTY@contesting.com
http://lists.contesting.com/mailman/listinfo/rtty

_______________________________________________
RTTY mailing list
RTTY@contesting.com
http://lists.contesting.com/mailman/listinfo/rtty

<Prev in Thread] Current Thread [Next in Thread>