RTTY
[Top] [All Lists]

[RTTY] Question

To: "FT-950 Reflector" <FT-950@yahoogroups.com>, "Rtty Contesting Reflector" <rtty@contesting.com>, "Writelog Reflector" <writelog@contesting.com>
Subject: [RTTY] Question
From: "DickT-W0RAA" <dickt@w0raa.com>
Date: Sun, 9 Jun 2013 12:04:28 -0600
List-post: <rtty@contesting.com">mailto:rtty@contesting.com>
I am using a Yaesu FT-950 with a SignaLink USB Interface.  Up until this 
weekend,
it has performed flawlessly in RTTY mode.  I usuall run PKT | LSB when 
running in
digital modes and have never had a problem.

Now, I cannot get the 950 to send out a signal when I send a macro using my
Writelog program (latest version).  I am not getting any RTTY output using 
MMTTY
either.

It shows that I am transmitting, but there is no
signal going out.  Zero power out.  In all other modes I ama getting full 
100 watts
power out (SSB/CW, etc).

I have not changed anythinh since the last contest,  Might anybody have any
suggestions as to where I should be looking?  The problem is only in RTTY 
mode.

TIA<

Dick
W0RAA

_______________________________________________
RTTY mailing list
RTTY@contesting.com
http://lists.contesting.com/mailman/listinfo/rtty

<Prev in Thread] Current Thread [Next in Thread>