Did you try as I suggested? What were the results? try sending:
AAAAA
BBBBB
CCCCC
DDDDD
etc,
let me know what, if any characters made it.....that will tell whether its
the pull up resistor or not....it was a simple fix on my microkeyer cable,
not sure what pins you need to short for your device, but before you do
anything, send the alphabet one character at a time and see what characters
get decoded....
On 5/9/2012 6:33:19 PM, Stein-Roar Brobakken (sroabr@online.no) wrote:
> Hi
>
> Yes, I tried ALL option with my FT920 and MMTTY, Writelog w/MMTTY ....and
> used DATA LSB(FSK) and FSK switch to FSK...
>
> In AFSK it was ok, but there seems to be low modulation..
> I
> don't like the AFSK Scoop in Writelog...
> FSK with MMTTY plugin is ONLY option for me to operate RTTY! Since I
> purcaed
> the the new FT-920 cable from microham last week.... it seems waste of
> bucks...
>
> The radio diddles and I can see the high and low tones on my decode...but
> no
> chance to copy it even parameter 2125, 170hz, REV or NOR with FT-920... it
> can't
> be decoded...somehow.. I tried dual decoder in 2nd pc with one REV and
> one Normal..
>
> It can be something wrong with the output on the FT920 ??? like WW3S
> said:
> " I use a FT-920 with an original Microkeyer when in VP9....it works, but
> it's a bear to setup.....first off, transmit the whole alphabet, and see
> if
> you can copy any of the letters...if you can copy half of them,but not the
> other, good chance ther pullup resistor in the 920 went bad....I'm not
> sure
> about the MKII, but with my microkeyer, I had to open the cable up and
> short
> 2 pins together, that cured it, W4TV could probably tell you if the same
> thing
_______________________________________________
RTTY mailing list
RTTY@contesting.com
http://lists.contesting.com/mailman/listinfo/rtty
|