Rag,
I use a FT-920 on RTTY FSK on a regular basis.
Here is my Radio setup:
Mode DATA-LSB (This defaults to LSB injection)
AFSK/FSK switch on the rear panel set to FSK.
Menu U-42 = Hi 2125
Menu U-43 = 170
Menu U-44 = Reverse (This depends on the FSK Keying interface)
FSK keying circuit should be on pin 1 of the Data connector and pin 2 is
ground.
MMTTY Setup:
Polarity = Normal
Setup | TX Tab. Setup the correct FSK com port for your interface
Setup | MISC tab. Set the TX port to one of the FSK selections.
I use a homebrewed FSK keying, so I'm not familiar with the MicroHam setup.
I don't know if you need to load EXTFSK.DLL or not. I use it here because my
interface uses a USB to serial converter.
Perhaps Joe/W4TV can assist in getting your MicroHam set up properly.
I use MMTTY under Logger32, but the above setting work for the FT-920 and
MMTTY as a standalone.
73s de Jim
W5IFP
> -----Original Message-----
> From: rtty-bounces@contesting.com [mailto:rtty-bounces@contesting.com]On
> Behalf Of Stein-Roar Brobakken
> Sent: Wednesday, May 09, 2012 12:53 AM
> To: rtty@contesting.com
> Subject: [RTTY] RTTY + FT920
>
>
> Hi
>
>
> Is there anyone out which have used FT-920 with FSK RTTY?
>
> I got a FT920 in shack to test for RTTY.
> I have tried to setup mine with a microHAM MKII..switched the
> radio to FSK
> and standard settings..2125 , 170 and also tried with setup in MMTTY..
> But I am not able to copy my sent RTTY at the other end...
> I do see the two spaced tones, but it's not quality RTTY and not able to
> decode it with another transceiver.. and I can either work any QSO :(
>
> Any suggestions????
>
> 73s LA6FJA Rag
>
>
> _______________________________________________
> RTTY mailing list
> RTTY@contesting.com
> http://lists.contesting.com/mailman/listinfo/rtty
_______________________________________________
RTTY mailing list
RTTY@contesting.com
http://lists.contesting.com/mailman/listinfo/rtty
|