> Note that a PK232 can be configured as the "front end" for a
> modem like the ST-8000, enabling it to be used with
> WinWarbler or other software that supports the PK232. Several
> WinWarbler users report excellent results with this configuration.
In this configuration the PK232 is simply acting as a 5-bit to
8-bit converter. It is accepting the raw 5-bit 45.45 baud
data stream from an external modem, doing a serial to parallel
conversion and mapping the 5-bit data characters to their 8-bit
equivalents (including shifting/unshifting as necessary). All
of the KAM units (as far as I can tell) are also capable of
using an external modem. However, the KAM's switched capacitor
filter demodulator is much superior to the op-amp active filter-
discriminator demodulator of the PK-232.
73,
... Joe, W4TV
> -----Original Message-----
> From: rtty-bounces@contesting.com
> [mailto:rtty-bounces@contesting.com] On Behalf Of Dave AA6YQ
> Sent: Sunday, January 25, 2009 12:02 AM
> To: rtty@contesting.com
> Subject: Re: [RTTY] Best RTTY program/hardware
>
>
> I use (and wrote) WinWarbler, which runs the MMTTY engine in
> one window, and an external modem in another. The external
> modem I use is a KAM'98. My RTTY activity is mostly DXing,
> with occasionally ragchewing.
>
> With the MMTTY engine and KAM'98 decoding the same signal
> and the MMTTY engine configured to use the EU1SA profile, I
> find MMTTY to be generally superior to the KAM'98, although
> there can be intervals within a QSO during which the reverse
> is true. Thus the decoded text from both is occasionally
> better the either alone. I have also been testing a new MMTTY
> profile based on EU1SA's work, but have not yet quantified
> its benefits.
>
> Note that a PK232 can be configured as the "front end" for a
> modem like the ST-8000, enabling it to be used with
> WinWarbler or other software that supports the PK232. Several
> WinWarbler users report excellent results with this configuration.
>
> 73,
>
> Dave, AA6YQ
>
>
>
> -----Original Message-----
> From: rtty-bounces@contesting.com
> [mailto:rtty-bounces@contesting.com]On
> Behalf Of Rick Ruhl
> Sent: Saturday, January 24, 2009 11:45 PM
> To: rtty@contesting.com
> Subject: Re: [RTTY] Best RTTY program/hardware
>
>
>
> -----Original Message-----
> From: rtty-bounces@contesting.com
> [mailto:rtty-bounces@contesting.com] On Behalf Of Bill, W6WRT
> Sent: Saturday, January 24, 2009 10:37 PM
> To: rtty@contesting.com
> Subject: Re: [RTTY] Best RTTY program/hardware
>
> ORIGINAL MESSAGE:
>
> On Sat, 24 Jan 2009 19:28:45 -0800 (PST), rick darwicki
> <n6pe@yahoo.com> wrote:
>
> >
> > Is there hardware out there that does a better job than software on
> > weak signals?
> >
> > Please respond to me directly so we don't start a cat
> > fight hi hi
>
> >REPLY:
>
> >With all due respect, I am replying on the reflector because
> this kind
> >of question is exactly why the reflector was begun in the
> first place.
> >This is the perfect venue for this kind of discussion.
>
> >Over the years I have run a number of side-by-side tests of software
> >and hardware to try to find out which is best at digging out weak
> >signals buried in the QRM and QRN. The comparisons showed
> that RiTTY by
> >K6STI (software) and a HAL ST-8000 (hardware modem) are nearly
> >identical in performance and I would place both equally at
> the top of
> >the list. Almost as good are MMTTY and MMVARI with MMVARI perhaps
> >having a slight edge. Next down the line was a KAM modem.
> Somewhere in
> >the middle were modems by Tono, AEA and the HAL DXP-38.
>
> >The worst I ever tested, by far, was an AEA DSP-232. Absolute junk.
>
> >My friend, Chen W7AY has a software program he wrote called
> CocoaModem
> >which I hear is very, very good but which runs only on a
> Mac. Haven't
> >tried that one yet.
>
> >No cat fights intended. I just call 'em like I see 'em. :-)
>
> >73, Bill W6WR
>
> Bill, Rick, et all:
>
> A Kam Plus is the best unit Ive ever used on RTTY, that's
> what I use in my shack.
>
> Since I write software for the Kantronics and Timewave units
> (and the MFJ too, and a beta for the DXP38 and SCS, which
> never got released), I was able to try all these out, and
> found by far the Kam Plus was the best TNC for RTTY.
>
> It's even better than some or all of the soundcard programs.
> Soundcard programs are limited by the quality of your soundcard.
>
> Rick - W4PC
> http://www.cssincorp.com
>
> (Btw, just because I write software for the Kam, doesn't mean
> you have to buy my programs, but from the TNC/soundcard
> standpoint, that's the best unit Ive seen.)
>
>
> _______________________________________________
> RTTY mailing list
> RTTY@contesting.com http://lists.contesting.com/mailman/listinfo/rtty
> No virus found in this incoming message.
> Checked by AVG.
> Version: 8.0.100 / Virus Database: 270.10.13/1912 - Release
> Date: 1/23/2009 6:54 PM
>
> _______________________________________________
> RTTY mailing list
> RTTY@contesting.com http://lists.contesting.com/mailman/listinfo/rtty
_______________________________________________
RTTY mailing list
RTTY@contesting.com
http://lists.contesting.com/mailman/listinfo/rtty
|