Hi Jamie,
Well, I think you are gonna have a problem with your setup, as you only have
2 COM ports available to Windows!
You will need to use those two for connecting WF1B to MMTTY (as a KAM), but
you now need a third port for the keying.
This port would need to be seen by WF1B, which rules out those on the
Byterunner card.
I am not sure about your particular rig, but is it possible you could use
VOX to key the rig?
I use VOX on mine, and found that it works quite well, although I can see
the advantage of using hard keying.
N1MM had a specially-written bit of code for CQWW, and there isn't one for
WAE (as yet!).
Hopefully, you will get a more helpful reply than this, but please do come
up in WAE!
Best 73 for now
Phil GU0SUP
**********************************************************************
This email and any files transmitted with it are confidential
and intended solely for the use of the individual to whom
they are addressed. If you have received this email in error
please notify the author immediately and delete it, together
with all copies, from your system. You are unauthorised to
directly, or indirectly, use, disclose, distribute, print or copy
any part of this message if you are not its intended recipient.
Any views or opinions expressed are solely those of the
author and do not necessarily represent those of
Guernsey Telecoms.
Information held on any of Guernsey Telecoms' computer
systems is the property of Guernsey Telecoms. Guernsey
Telecoms reserves the right to monitor and review the
content of all information, messages and attachments sent
to or from this e-mail address.
**********************************************************************
|