RFI
[Top] [All Lists]

Re: [RFI] USB port closing

To: rfi@contesting.com
Subject: Re: [RFI] USB port closing
From: Jim Brown <jim@audiosystemsgroup.com>
Reply-to: jim@audiosystemsgroup.com
Date: Thu, 18 Aug 2022 01:11:03 -0700
List-post: <mailto:rfi@contesting.com>
On 8/18/2022 12:13 AM, Martin Sole wrote:
As I understand it the station is located inside the house and the connection to the outside ground is approximately 20 feet. Right now I can only assume there is a lot of RF inside the station though before moving things around in the same shack the IC-7300 was working perfectly for very long periods of time.

Hi Martin,

The use of the word "ground" to describe four different concepts since the earliest days of radio has led to massive mis-understandings of fundamental concepts. A very smart Canadian electrical engineer and ham put it very poetically in lectures he gave on the topic -- "the earth is not a sump into which hum, buzz, noise, and RFI are poured!"

A connection to earth has NOTHING to do with killing hum, buzz, or RFI, but it is critical for lightning protection. What DOES matter a LOT more is BONDING -- connections of all grounded things in a home, station, or building. All that bonding is also a critical element of lightning protection. I've covered all of this in the slides for a talk I've done at a couple of US west coast ham conventions and to several clubs. They are here.

http://k9yc.com/GroundingAndAudio.pdf

There are differences from one country/continent to another about how power systems are bonded to earth and to everything else. I don't know anything about things in your country. But everything else in the slide deck applies around the world.

As to USB ports closing -- there are settings in Windoze for power saving that can be set turn off stuff, including USB ports, after some pre-set idle time.

73, Jim K9YC
_______________________________________________
RFI mailing list
RFI@contesting.com
http://lists.contesting.com/mailman/listinfo/rfi

<Prev in Thread] Current Thread [Next in Thread>