No problems here. I tried it out on an existing QDF file and then
setup a new file for the upcoming IOTA contest. It followed band
and mode changes on the FT1000MP without fault.
73 Chris G3SJJ (GU8D EU114 in IOTA Contest)
----- Original Message -----
From: alsopb <alsopb@gloryroad.net>
To: <na-user@contesting.com>
Sent: Thursday, July 04, 2002 1:58 PM
Subject: [NA-User] NO CW 10.57
> Thanks for your replies regarding version 10.57
>
> Others are having the same problems.
>
> I found out that the code seems to be reading the wrong mode from the
> radio.
> If one sets no rig, the program comes up in cw and the cw functions
> work.
> (No rig control, ugh!)
>
> If one saves this file and then restarts the program, if very briefly
> comes up as CW until the rig is polled. Then it changes to SSB mode.
>
> This maybe a function on the rig. This problem occurs with an FT100D
> specified. The main op codes for this rig (except for the freq scale
> factor) are the same as the FT1000MP. Specifying the rig as an
> FT1000MP and faking it out so that freq is valid by using 20M (FT100
> reports 7Mhz), results in the same problem.
>
> So if you're planning on using this version, check it out sometime
> before 1 minute before the contest starts.
>
> 73 de Brian/K3KO
> _______________________________________________
> NA-User mailing list
> NA-User@contesting.com
> http://lists.contesting.com/mailman/listinfo/na-user
|