I have recently (yesterday) acquired a second IC-765. This came with the
CI-V interface.
I have used my current IC-765 with NA using a homebrew interface. As they
sit right now, RIG-1 is on COM-3 and RIG-2 is on COM-4. All is well and
communicating happily . . .
I would like to combine the communications to both radios into one COM port,
(so I can do SO2R from a laptop). The Icom (and the homebrew) computer
interfaces allow you to use several radios on one interface.
How do I do this?
I assume that if I have both radios hooked to the interface on COM X, and NA
configured to RIG-1=IC-765 and RIG-2=IC-765, NA and the interface will not
know which radio is which and become confused.
I assume I will have to change the address (HEX value/assignment) for one of
the radios. If I leave RIG-1 the way it is, and set RIG-2 to, say, an
IC-781, and change the radio 2 to communicate like an IC-781, can NA talk to
both radios on the same COM port?
Don WX3M
Don Chisholm
dchishol@oakland.edu
http://www.oakland.edu/~dchishol/
"I didn't do it. Nobody saw me. You can't prove anything." - Bart Simpson
|