Re: [Karlnet] Lockups KN205

["Steve Loomis" <loomiss@cox.net>]

I think we are at about 14 to15 volts. It is on the end of a 100 foot run of 
Cat 5 so I don't remember exactly how much it is.  I measured it when I put 
the higher voltage power supply on it, but that was almost a year ago and it 
has been running fine ever since.

----- Original Message ----- 
From: "Mark McKibbin" <mark@team.dcsi.net.au>
To: "Karlnet Mailing List" <karlnet@WISPNotes.com>
Sent: Thursday, December 16, 2004 11:49 PM
Subject: RE: [Karlnet] Lockups KN205


How much higher?


Regards

Mark McKibbin
DCS Internet
64 Queen St
Warragul
Victoria   3820
Australia
Ph: +61 356 241 111 (direct)
Fax +61 356 220 617
mark@team.dcsi.net.au
www.dcsi.net.au

-----Original Message-----
From: Steve Loomis [mailto:loomiss@cox.net]
Posted At: Friday, 17 December 2004 4:35 PM
Posted To: KarlNet
Conversation: [Karlnet] Lockups KN205
Subject: Re: [Karlnet] Lockups KN205

We had problems at 12 volts and went higher, problems gone.
----- Original Message ----- 
From: "Mark McKibbin" <mark@team.dcsi.net.au>
To: "Karlnet Mailing List" <karlnet@WISPNotes.com>
Sent: Thursday, December 16, 2004 11:31 PM
Subject: RE: [Karlnet] Lockups KN205


The manual says 15-48V for poe but 12v-48v for the DC jack, do you think
that's right? Could be a typo.

Regards

Mark McKibbin
DCS Internet
64 Queen St
Warragul
Victoria   3820
Australia
Ph: +61 356 241 111 (direct)
Fax +61 356 220 617
mark@team.dcsi.net.au
www.dcsi.net.au

-----Original Message-----
From: Alex Phillips [mailto:alexp@rbns.net]
Posted At: Friday, 17 December 2004 4:04 PM
Posted To: KarlNet
Conversation: [Karlnet] Lockups KN205
Subject: RE: [Karlnet] Lockups KN205

There it is.  15vdc is the min spec voltage.  You should bump it up to
24 or something.

-----Original Message-----
From: karlnet-bounces@WISPNotes.com
[mailto:karlnet-bounces@WISPNotes.com] On Behalf Of Mark McKibbin
Sent: Thursday, December 16, 2004 11:54 PM
To: Karlnet Mailing List
Subject: RE: [Karlnet] Lockups KN205

Only one radio card, 13.7v direct not poe (I have a gel cell floating
across power so very sloth), different towers same flakeyness latest
firmware.

Regards

Mark McKibbin
DCS Internet
64 Queen St
Warragul
Victoria   3820
Australia
Ph: +61 356 241 111 (direct)
Fax +61 356 220 617
mark@team.dcsi.net.au
www.dcsi.net.au

-----Original Message-----
From: Steve Loomis [mailto:loomiss@cox.net]
Posted At: Friday, 17 December 2004 10:12 AM
Posted To: KarlNet
Conversation: [Karlnet] Lockups KN205
Subject: Re: [Karlnet] Lockups KN205

We had that problem for a while, but raised the POE voltage to the point

where we were getting at least 12 to 15 volts at the end of a 100' Cat 5

run.  We can go months and months without a reset or lockup.  We have
other
KN205's  on short cat5 runs or direct power plug in and have had NO
problems
with them.  Before we got them upgraded from KN200's we had lots of
problems, not now...

Steve Loomis
vroomwireless.com

----- Original Message ----- 
From: "Alex Phillips" <alexp@rbns.net>
To: "'Karlnet Mailing List'" <karlnet@WISPNotes.com>
Sent: Thursday, December 16, 2004 5:02 PM
Subject: RE: [Karlnet] Lockups KN205


> I have that problem about 1 a month.  I am going to upgrade to 4.46 to
> see if that helps.
>
> Sound to me that you have a power supply problem though.
>
> What is your power sup and cable length.
>
> -----Original Message-----
> From: karlnet-bounces@WISPNotes.com
> [mailto:karlnet-bounces@WISPNotes.com] On Behalf Of Mark McKibbin
> Sent: Thursday, December 16, 2004 4:58 PM
> To: Karlnet Mailing List
> Subject: [Karlnet] Lockups KN205
>
> Is anyone getting their KN205 (isp base) locking up, I seem to have to
> get in the car and reset one or two of our bases every week. Only
seems
> to happen on the ones with above 20 users. Will the KN250 be any
better?
> I don't mind spending the money on a better solution I just want gear
> that stays up for months at a time.
>
> Regards
>
> Mark McKibbin
> DCS Internet
> 64 Queen St
> Warragul
> Victoria   3820
> Australia
> Ph: +61 356 241 111 (direct)
> Fax +61 356 220 617
> mark@team.dcsi.net.au
> www.dcsi.net.au
>
> _______________________________________________
> Karlnet mailing list
> Karlnet@WISPNotes.com
> http://lists.wispnotes.com/mailman/listinfo/karlnet
>
>
> _______________________________________________
> Karlnet mailing list
> Karlnet@WISPNotes.com
> http://lists.wispnotes.com/mailman/listinfo/karlnet

_______________________________________________
Karlnet mailing list
Karlnet@WISPNotes.com
http://lists.wispnotes.com/mailman/listinfo/karlnet

_______________________________________________
Karlnet mailing list
Karlnet@WISPNotes.com
http://lists.wispnotes.com/mailman/listinfo/karlnet


_______________________________________________
Karlnet mailing list
Karlnet@WISPNotes.com
http://lists.wispnotes.com/mailman/listinfo/karlnet

_______________________________________________
Karlnet mailing list
Karlnet@WISPNotes.com
http://lists.wispnotes.com/mailman/listinfo/karlnet

_______________________________________________
Karlnet mailing list
Karlnet@WISPNotes.com
http://lists.wispnotes.com/mailman/listinfo/karlnet

_______________________________________________
Karlnet mailing list
Karlnet@WISPNotes.com
http://lists.wispnotes.com/mailman/listinfo/karlnet 

_______________________________________________
Karlnet mailing list
Karlnet@WISPNotes.com
http://lists.wispnotes.com/mailman/listinfo/karlnet