Try pulling the wireless cards out and try reloading the license. Also, you
probably need to clear your arp cache "arp -d *" at a command prompt after
you change the IP Address.
-----Original Message-----
From: karlnet-bounces@WISPNotes.com
[mailto:karlnet-bounces@WISPNotes.com]On Behalf Of Dan Metcalf
Sent: Wednesday, May 05, 2004 3:55 PM
To: bradlists@mnns.com; 'Karlnet Mailing List'
Subject: RE: [Karlnet] Configuring KN-100 SAT SOHO (possible dumb
question)
Sounds like invalid license
> -----Original Message-----
> From: karlnet-bounces@WISPNotes.com
[mailto:karlnet-bounces@WISPNotes.com]
> On Behalf Of Brad Gass
> Sent: Wednesday, May 05, 2004 4:51 PM
> To: Karlnet Mailing List
> Subject: [Karlnet] Configuring KN-100 SAT SOHO (possible dumb
question)
>
> OK, I've got a really odd problem here that I'm either missing
something
> dumb (always possible), or something really bizarre is happening.
>
> I've got a KN-100 that I had to do a forced-reload procedure on. I go
> into forced-reload mode, set an IP address, open the correct BIN and
LKF,
> save it to the board, and it reboots as it should.
>
> Then, I do a local scan, it finds the unit, I assign an IP to it (same
one
> I used in forced-reload mode), and it's fine. I can sit there all day
> long (literally, been pinging/monitoring it for >24 hours now) and
> connectivity is perfect.
>
> I configure the IP settings (in this case, 192.168.251.99,
255.255.255.0,
> gateway 192.168.251.254), touch nothing else, save the config to the
unit,
> and it reboots.
>
> Here's where it gets wierd.
>
> Right after reboot, the unit responds to pings a few times (4-8 to be
> exact), and then it drops off the face of the Earth. A local network
scan
> doesn't see it, nothing. I power cycle the unit and I get the same
thing.
>
> What am I doing wrong here? I've fiddled with the ethernet port
settings
> (defaults to 10M/half, tried 100M/auto and auto/auto with the same
> results), and tried two different hubs/switches (Linksys 5 port
> autosensing and a D-Link 8 port 10/100) and neither did anything
> different.
>
> Link lights are fine on both the KN-100 and the switch port.
>
> Am I missing something really dumb, or is there something deeper going
on?
> I'm trying to load 4.44 into the unit, and when it stops responding,
the
> power LED is green, ethernet green (and see's activity), middle two
LED's
> red BTW.
>
> Thanks!
>
>
> Brad
>
>
>
> _______________________________________________
> Karlnet mailing list
> Karlnet@WISPNotes.com
> http://lists.wispnotes.com/mailman/listinfo/karlnet
> --
> [This E-mail scanned for viruses by Declude Virus]
>
--
[This E-mail scanned for viruses by Declude Virus]
_______________________________________________
Karlnet mailing list
Karlnet@WISPNotes.com
http://lists.wispnotes.com/mailman/listinfo/karlnet
_______________________________________________
Karlnet mailing list
Karlnet@WISPNotes.com
http://lists.wispnotes.com/mailman/listinfo/karlnet
|