Re: [Karlnet] Bridge and route on the same KN200

[John Tully <tully@mikrotik.com>]

You can do that with a MikroTik RouterOS AP.
http://www.mikrotik.com/docs2.8/interface/bridge.main

John
www.mikrotik.com

At 06:15 PM 4/27/2004, you wrote:
> It's a shame that with 4 interfaces on the KN-200 that you can't define L2 
> bridge groups - For example, define Interfaces 1 & 2 as "Group 1" and 
> Interfaces 3 & 4 as "Group 2" so that you can then route between Group 1 & 
> Group 2.
>
> *********** REPLY SEPARATOR  ***********
>
> On 2004-04-26 at 10:34 PM Paul Horak wrote:
>
> >Anybody know if you can bridge and route on the same
> >radio (KN200 in this rather bizarre case :-))? If so,
> >please can you share the config? Turning on routing
> >seems to automatically deny bridging of IP traffic.
> >
> >Cheers,
> >
> >Paul
> >
> >
> >
> >
> >
> >__________________________________
> >Do you Yahoo!?
> >Win a $20,000 Career Makeover at Yahoo! HotJobs
> >http://hotjobs.sweepstakes.yahoo.com/careermakeover
> >_______________________________________________
> >Karlnet mailing list
> >Karlnet@WISPNotes.com
> >http://lists.wispnotes.com/mailman/listinfo/karlnet
>
>
>
> _______________________________________________
> Karlnet mailing list
> Karlnet@WISPNotes.com
> http://lists.wispnotes.com/mailman/listinfo/karlnet

_______________________________________________
Karlnet mailing list
Karlnet@WISPNotes.com
http://lists.wispnotes.com/mailman/listinfo/karlnet