The board is mounted in one of your 19dB antennas, so I don't think the
button is being pressed...
I don't seem to see a section for network ID, can you point this out?
Regards,
Jayson A. Baker
Peak Internet Solutions
-----Original Message-----
From: karlnet-bounces@WISPNotes.com [mailto:karlnet-bounces@WISPNotes.com]
On Behalf Of KarlNet Support
Sent: Tuesday, March 09, 2004 5:01 PM
To: Karlnet Mailing List
Subject: RE: [Karlnet] KN50 Configuration... are we doing it wrong?
Jason,
When the KN-50 shows up as compatible, one of the following is in question.
The channel, Network ID or System Access Passphrase does not match. Keep in
mind your Base must be set to TC ISP Base and your channel and network ID
must match ex. Channel 3, NID 3.
As far as the unit being set to defaults, be sure the reset button is not
accidentally being pressed, very easy to do when trying to plug in the
ethernet.
KarlNet Technical Support
http://www.karlnet.com/Support/Supportmain.htm
614-822-5275 x 128
-----Original Message-----
From: karlnet-bounces@WISPNotes.com
[mailto:karlnet-bounces@WISPNotes.com]On Behalf Of Jayson A. Baker
Sent: Tuesday, March 09, 2004 6:49 PM
To: 'Karlnet Mailing List'
Subject: RE: [Karlnet] KN50 Configuration... are we doing it wrong?
Are these things JUNK, or what???
We set to auto channel scan, then our AP sees the KN-50 for a few seconds,
then it drops out, and over and over again.
So we set it to channel 1 only, our AP shows it in "Compatible" mode, with
good SNR, etc. but the KN-50 shows no signal at all. Passes no traffic,
etc.
We must be doing something wrong... please advise.
Regards,
Jayson A. Baker
Peak Internet Solutions
-----Original Message-----
From: karlnet-bounces@WISPNotes.com [mailto:karlnet-bounces@WISPNotes.com]
On Behalf Of Jayson A. Baker
Sent: Tuesday, March 09, 2004 4:32 PM
To: 'Karlnet Mailing List'
Subject: [Karlnet] KN50 Configuration... are we doing it wrong?
Hi,
Seems as though no matter what we input into the configuration pages for
these KN-50 board, when we save and restart the unit, it sets everything
back to defaults.
Are we doing something wrong here, or does Karlnet need to do some serious
software upgrades to these boards?
Regards,
Jayson A. Baker
Peak Internet Solutions
Phone: (719) 686-1490
Facsimile: (719) 686-1864
E-Mail: jbaker@peakinet.net
Web: http://www.peakinet.net/
_______________________________________________
Karlnet mailing list
Karlnet@WISPNotes.com
http://lists.wispnotes.com/mailman/listinfo/karlnet
_______________________________________________
Karlnet mailing list
Karlnet@WISPNotes.com
http://lists.wispnotes.com/mailman/listinfo/karlnet
---
Incoming mail is certified Virus Free.
Checked by AVG anti-virus system (http://www.grisoft.com).
Version: 6.0.605 / Virus Database: 385 - Release Date: 3/1/2004
---
Outgoing mail is certified Virus Free.
Checked by AVG anti-virus system (http://www.grisoft.com).
Version: 6.0.605 / Virus Database: 385 - Release Date: 3/1/2004
_______________________________________________
Karlnet mailing list
Karlnet@WISPNotes.com
http://lists.wispnotes.com/mailman/listinfo/karlnet
_______________________________________________
Karlnet mailing list
Karlnet@WISPNotes.com
http://lists.wispnotes.com/mailman/listinfo/karlnet
|