Are these things JUNK, or what???
We set to auto channel scan, then our AP sees the KN-50 for a few seconds,
then it drops out, and over and over again.
So we set it to channel 1 only, our AP shows it in "Compatible" mode, with
good SNR, etc. but the KN-50 shows no signal at all. Passes no traffic,
etc.
We must be doing something wrong... please advise.
Regards,
Jayson A. Baker
Peak Internet Solutions
-----Original Message-----
From: karlnet-bounces@WISPNotes.com [mailto:karlnet-bounces@WISPNotes.com]
On Behalf Of Jayson A. Baker
Sent: Tuesday, March 09, 2004 4:32 PM
To: 'Karlnet Mailing List'
Subject: [Karlnet] KN50 Configuration... are we doing it wrong?
Hi,
Seems as though no matter what we input into the configuration pages for
these KN-50 board, when we save and restart the unit, it sets everything
back to defaults.
Are we doing something wrong here, or does Karlnet need to do some serious
software upgrades to these boards?
Regards,
Jayson A. Baker
Peak Internet Solutions
Phone: (719) 686-1490
Facsimile: (719) 686-1864
E-Mail: jbaker@peakinet.net
Web: http://www.peakinet.net/
_______________________________________________
Karlnet mailing list
Karlnet@WISPNotes.com
http://lists.wispnotes.com/mailman/listinfo/karlnet
_______________________________________________
Karlnet mailing list
Karlnet@WISPNotes.com
http://lists.wispnotes.com/mailman/listinfo/karlnet
|