I'm assuming that I don't have that board, as I'm using J3 for a fan header,
and the temp reported is 31C and the fan keeps merrily blowing away.
Or...is there some software that has to be loaded to make it work? It would
be very, very nice to have this, as the fan does use a bit of power, and
it's at a real premium where I'm locating this radio. (solar) During the
winter, with the ambient so low, it would be nice not to have the fan
blowing frigid air over the radio, not to mention that sunlight is a bit
scarce during this time.
----- Original Message -----
From: "Caleb Carroll" <karlnet@pathcom.ca>
To: "Norm Young" <lists@applegatebroadband.net>; "Karlnet Mailing List"
<karlnet@WISPNotes.com>
Sent: Tuesday, October 07, 2003 9:45 AM
Subject: Re: [Karlnet] kn100/200 temp readings
FYI everyone: The new KN-100 & 200 boards now have temperature control.
The fan starts operating at 45deg C. When/if the board reaches 30deg C, the
fan will turn its self off. The fan comes on for a second or two when you
first apply power to the board and then shuts off.
*********** REPLY SEPARATOR ***********
On 2003-Oct-06 at 10:00 PM Norm Young wrote:
>Eric, you need the latest version of the KN-200 board AND/OR you need
>v4.43a, I'm gathering from the questions and input I'm getting to get a
>temp
>reading. It shows up on the Remote Statistics area in the configurator.
>
>Norm
>
>
>----- Original Message -----
>From: "admin " <admin@mail.warpspeedinternet.ws>
>To: <karlnet@WISPNotes.com>
>Sent: Monday, October 06, 2003 7:08 AM
>Subject: [Karlnet] kn100/200 temp readings
>
>
>> Hi all,
>>
>> Where do you get the configurator which shows the board temp? I looked
>thru the Karlnet site and don't see it.
>>
>> TIA,
>> Eric
>>
>>
>> _______________________________________________
>> Karlnet mailing list
>> Karlnet@WISPNotes.com
>> http://lists.wispnotes.com/mailman/listinfo/karlnet
>>
>
>
>_______________________________________________
>Karlnet mailing list
>Karlnet@WISPNotes.com
>http://lists.wispnotes.com/mailman/listinfo/karlnet
|