>I had some troubles with the karlnet configurator interface and
>reflash procedures. if karlnet takes notes from this list, I'd suggest:
>- resize the window when it open. it's smaller than it should!
>- when I upload the firmware, no matter what I tried changing
>in the config, the unit receive a new IP address, 198.17.74.254
you should select the unit, and do "change ip" command, then you don't have
to change your computers ip
>after that, I did the bridge setup and it worked (I put one unit
>in Base mode and the other in Satelite mode. Is this the correct way?)
yes
>the only thing I couldn't figure out whas how to mac filter the units
>so they only see each other. When I inform the remote ethernet
>mac address on one side or the other (Turbocell "filtering" button),
>the communication is interrupt, although I could see the remove
.unit on the wireless tests screens.
can you expand on that?
-charles
|