This indicates is that the card comes in two versions...
version 1 is 200mW, certified by the FCC for use in North America
version 2 is 100mW, certified by the CE for use outside North America
*********** REPLY SEPARATOR ***********
On 2003-May-07 at 3:34 PM Bob Hrbek wrote:
>Look again at the PDF:
>
>RF Output Power 23dBm(200mW)--FCC
>
>20dBm(100mW)--CE
>
>
>
>
>
>----- Original Message -----
>From: "Caleb Carroll" <karlnet@pathcom.ca>
>To: "Karlnet Mailing List" <karlnet@WISPNotes.com>
>Sent: Wednesday, May 07, 2003 1:54 PM
>Subject: Re: [Karlnet] Engeniustech Prisim 2 cards...doesn't seem to be
>working properly
>
>
>> Notice the "CE" certification at the end of the line? This is a card
>made
>for use in Europe. Are you somewhere in europe? If so, you probably won't
>be able to legally use the FCC certified 200mW card.
>>
>> *********** REPLY SEPARATOR ***********
>>
>> On 2003-May-07 at 10:43 AM Bob Hrbek wrote:
>>
>> >I'm using one of these engeniustech cards in an AP-1000 w/ Karlnet
>> >ISP-Base
>> >4.31
>> >http://www.engeniustech.com/cs/file/2511/el2511cdplusext2spec.pdf
>> >
>> >The specs say it can operate at 200mw or 100mW. Does it run at 200mW
>by
>> >default? By watching signal levels it seems like it is only operating
>at
>> >100mW.
>> >
>> >Anybody else using them and seeing the signal levels relavant to 200mW
>> >radios?
>> >
>> >-bob
>> >
>> >_______________________________________________
>> >Karlnet mailing list
>> >Karlnet@WISPNotes.com
>> >http://lists.wispnotes.com/mailman/listinfo/karlnet
>>
>>
>>
>>
>> _______________________________________________
>> Karlnet mailing list
>> Karlnet@WISPNotes.com
>> http://lists.wispnotes.com/mailman/listinfo/karlnet
>>
>
>_______________________________________________
>Karlnet mailing list
>Karlnet@WISPNotes.com
>http://lists.wispnotes.com/mailman/listinfo/karlnet
|