The only bin file that I can get to work is the 4.43a. I have downloaded the
4.00 bin about 5 times and I get an error message that says (Signature check
failed for file c:\downloads\karlnet\knrgotcn-v400.bin
That is the KNRGOTCN-v400.
The only bin I can get to work is the KNRGOTCN-v4.43a.
I have verified the MAC and it is correct on the license-it.com site.
Maybe I just need to find a good 4.00 bin file.
Nate
-----Original Message-----
From: karlnet-bounces@WISPNotes.com
[mailto:karlnet-bounces@WISPNotes.com]On Behalf Of Charles Chia Sheng Wu
Sent: Thursday, March 27, 2003 8:23 AM
To: Karlnet Mailing List
Subject: RE: [Karlnet] WPBASE+ Problems
check you switch? computer?
which version .bin file are you using (4.0 or 4.43a)?
an FYI
for the WPBASE+
Power LED is #5
next 2 LEDs (#3 & #4) are for the wireless cards
right 2 LEDs (#2 & #1) are for the Ethernet ports
forced reload button is the little circular button near the power jack
-Charles
-----Original Message-----
From: karlnet-bounces@WISPNotes.com
[mailto:karlnet-bounces@WISPNotes.com]On Behalf Of Nate McLain
Sent: Wednesday, March 26, 2003 6:57 PM
To: Karlnet Mailing List
Subject: [Karlnet] WPBASE+ Problems
Ok, I have a WPBASE+ and after I have flashed it I just get a Green Power
light on LED5. And then 4 Red LEDs on the rest. And I can't scan it with the
configurator. If I put it back in base boot mode then it just shows up with
the Status of NEW. Like it was never flashed.
It is almost like there is something preventing it from being flashed.
Does anyone have any documentation on these.... :-D LOL
Nate
_______________________________________________
Karlnet mailing list
Karlnet@WISPNotes.com
http://lists.wispnotes.com/mailman/listinfo/karlnet
_______________________________________________
Karlnet mailing list
Karlnet@WISPNotes.com
http://lists.wispnotes.com/mailman/listinfo/karlnet
|