I got it fixed on my own.
I had not specified a route for the ethernet interface so the routing table
was incomplete. There was one route for one of the wirless interfaces so I
logged in via that wireless interface and fixed the routing table and now
everything works.
So tell me why a bad routing table would render the unit completely
inaccessible even during a forced reload? Does that make any sense at all?
Oh I forgot, you are not my reseller so you won't answer that.
--
Mark Wauchope, Director of Engineering, Kivanet Inc
776 East Second Avenue Suite 207 Durango, CO 81301
970-749-2711 http://www.ekiva.net/ mark@ekiva.net
-----Original Message-----
From: karlnet-admin@WISPNotes.com [mailto:karlnet-admin@WISPNotes.com] On
Behalf Of Charles Chia Sheng Wu
Sent: Thursday, December 19, 2002 1:55 PM
To: karlnet@WISPNotes.com
Subject: RE: [Karlnet] AP-1000 Factory Reset
>Well I specifically said twice in my message that forced reload did not
work
>and I am trying to do factory reset. Forced reload does not revert to
>factory flash and settings. But thanks anyway.
ask your reseller...
-Charles
_______________________________________________
Karlnet mailing list
Karlnet@WISPNotes.com http://lists.wispnotes.com/mailman/listinfo/karlnet
|