Karlnet
[Top] [All Lists]

Re: [Karlnet] SNR at base?

To: <karlnet@wispnotes.com>
Subject: Re: [Karlnet] SNR at base?
From: "Bob Hrbek" <bhrbek@jagwireless.com>
Reply-to: karlnet@WISPNotes.com
Date: Tue, 12 Nov 2002 22:54:45 -0600
List-post: <mailto:karlnet@WISPNotes.com>
sounds kind of weak for an amped signal.  Are you using an amp at the AP as
well?  But what distance are we talking about here...what do the RF calcs
say and what is the noise floor?


----- Original Message -----
From: "George Minich" <gminich@toshiba.ca>
To: <karlnet@WISPNotes.com>
Sent: Tuesday, November 12, 2002 10:29 PM
Subject: [Karlnet] SNR at base?


>   Would you guys consider a 19db SNR at the base of an amped setup a good
> SNR?  Some customers further out have a 15 to 17db.  This seems low, but
is
> about the best I was able to score.  This is through the use of 19dbi
grids
> at the satellite end.  What do you guys typically see for base SNR if your
> base is amped?
>
> Thanks
>
> George
>
> ----- Original Message -----
> From: "Demarc (tony) 908-996-7995" <tonylist@wwwbiz.com>
> To: <karlnet@WISPNotes.com>
> Sent: Tuesday, November 12, 2002 10:57 PM
> Subject: RE: [Karlnet] KN Throughput
>
>
> > John
> >
> > You can do this with two AP-1000 and good LOS and RF level to about to
> > about 5Mb. With a little tweaking to get it optimal performance. Email
> > me off list and we can go thought the details.
> >
> > Sincerely
> > Tony Morella
> > Demarc Technology Group
> > Office: 908-996-7995
> > Cell: 908-246-9170
> > Fax: 908-847-0202
> > email: tony@demarctech.com
> > http://www.demarctech.com
> > Open Chat Server http://www.demarctech.com:8000
> > Yahoo IM: tonymorella
> > Wireless Solution Provider
> >
> >
> > > -----Original Message-----
> > > From: karlnet-admin@WISPNotes.com
> > > [mailto:karlnet-admin@WISPNotes.com] On Behalf Of John Maxwell
> > > Sent: Tuesday, November 12, 2002 8:26 PM
> > > To: karlnet@WISPNotes.com
> > > Subject: [Karlnet] KN Throughput
> > >
> > >
> > > Anyone out there know the actual throughput that we can get
> > > on a KN TC PtP link?  To this point, I've only seen about
> > > 2mbps at the most.  I understood that they could do about 5-6mbps.
> > >
> > > Any words of wisdom?
> > >
> > > _______________________________________________
> > > Karlnet mailing list
> > > Karlnet@WISPNotes.com
> > > http://lists.wispnotes.com/mailman/listinfo/ka> rlnet
> > >
> >
> > _______________________________________________
> > Karlnet mailing list
> > Karlnet@WISPNotes.com
> > http://lists.wispnotes.com/mailman/listinfo/karlnet
> >
> >
>
> _______________________________________________
> Karlnet mailing list
> Karlnet@WISPNotes.com
> http://lists.wispnotes.com/mailman/listinfo/karlnet
>


<Prev in Thread] Current Thread [Next in Thread>