If you have 20 business clients on the AP, does that indicate that you have
20 business NETWORKS on this AP? Each network could have many workstations.
You could have 200+ computers hitting that single AP.
Ok... enough speculation... in answer to your question, you should look at
the specifics. How much traffic is flowing through your AP? What type of
traffic is flowing through the AP? Is something different about the traffic
flow during those 700ms spikes? What about signal SNR to/from your clients
do ANY of your clients have weak links with lots of lost
packets/retransmissions? Dig a little lower than to assume a Firmware
issue. It might be firmware, but it might be something to do with the
environment and the task at hand.
----- Original Message -----
From: "Brenden Cooper" <brenden@megalink.com.au>
To: <karlnet@WISPNotes.com>
Sent: Thursday, October 31, 2002 6:16 AM
Subject: [Karlnet] 3.88 polling will not work over 13 clients
> I have a base station on the roof of my building I have tried using a
> RG1000 with 3.88 Firmware but we came into problems when we got to 13
> clients, I asked Karlnet and they told me that the RG didn't have the
> processing power so we updated it to a AP1000. The funny thing is we
> still have the problem, Polling doesn't work. The ping fly out to the
> 700ms on the RG and the AP We have around 20 Business client on this
> unit and the only way we can stop it from happening is to turn the
> polling off which mean we get the other problem that having no polling
> causes (hidden node etc.)
>
> Any body got any ideas?
>
> Thanks
> Brenden
> www.megalink.com.au
>
> _______________________________________________
> Karlnet mailing list
> Karlnet@WISPNotes.com
> http://lists.wispnotes.com/mailman/listinfo/karlnet
>
>
|