I will check firmware next
MAC is correct
---------- Original Message ----------------------------------
From: "Charles Chia Sheng Wu" <cwu@cwlab.net>
Reply-To: karlnet@WISPNotes.com
Date: Thu, 24 Oct 2002 12:17:12 -0500
>45 red LEDS means either
>
>1. incorrect MAC address
>2. old firmware on card (live v4ish)
>
>press reset...and will the LEDS are flashing (probably about 1 sec into it),
>HOLD down Reload until the power LED turns amber
>
>then you're set
>
>-----Original Message-----
>From: karlnet-admin@WISPNotes.com [mailto:karlnet-admin@WISPNotes.com]On
>Behalf Of admin
>Sent: Thursday, October 24, 2002 12:07 PM
>To: karlnet@WISPNotes.com
>Subject: [Karlnet] RG1100 all red LED's
>
>
>After installing SR4000 on RG. I have 4 red leds upon scanning for RG. The
>forced reload procedure found in doc's doesnt seem to work. Press reset,
>wait 5 sec for restart of RG and then hold reload for 30 sec until all LED's
>turn amber. Does anyone have any ideas.
>Thanks,
>
>
>--
>Eric L. Johnson
>WarpSpeed Internet
>1-361-563-3742
>--
>_______________________________________________
>Karlnet mailing list
>Karlnet@WISPNotes.com
>http://lists.wispnotes.com/mailman/listinfo/karlnet
>
>_______________________________________________
>Karlnet mailing list
>Karlnet@WISPNotes.com
>http://lists.wispnotes.com/mailman/listinfo/karlnet
>
--
Eric L. Johnson
WarpSpeed Internet
1-361-563-3742
--
|