45 red LEDS means either
1. incorrect MAC address
2. old firmware on card (live v4ish)
press reset...and will the LEDS are flashing (probably about 1 sec into it),
HOLD down Reload until the power LED turns amber
then you're set
-----Original Message-----
From: karlnet-admin@WISPNotes.com [mailto:karlnet-admin@WISPNotes.com]On
Behalf Of admin
Sent: Thursday, October 24, 2002 12:07 PM
To: karlnet@WISPNotes.com
Subject: [Karlnet] RG1100 all red LED's
After installing SR4000 on RG. I have 4 red leds upon scanning for RG. The
forced reload procedure found in doc's doesnt seem to work. Press reset,
wait 5 sec for restart of RG and then hold reload for 30 sec until all LED's
turn amber. Does anyone have any ideas.
Thanks,
--
Eric L. Johnson
WarpSpeed Internet
1-361-563-3742
--
_______________________________________________
Karlnet mailing list
Karlnet@WISPNotes.com
http://lists.wispnotes.com/mailman/listinfo/karlnet
|