Lister,
Have any of you seen this problem? I have an AP1000 with the TurboCell ISP
Base upgrade. I got it loaded with some help from a few of you. Thanks. It is
connected ethernet side via crossover cable to a desktop and communication is
no problem thru the configurator.
I installed the TurboCell NDIS on my laptop which already had the Win98
drivers for the orincoc card. During the install the wizard repeatedly and
alternately asked for pubprot and secur32 files. I located these files and
pointed the wizard to them. After all was said and done a message stated I
already had a device installed and couldn't run both drivers. So I switched to
plan B and erased the drivers listed and went with a fresh install. I basically
went thru the same thing as above but when it was done, it had the TC setup for
client manager and wanted the key, NWID, rate, ect. With all info typed in, I
restarted the system and started client manager. It stated no driver present. I
switched the profile to AP and the driver appeared. Switched it back to TC and
the driver is still there but the manager wont search off of channel 10. I go
to the desktop and do a link test via configurator and it shows excellent
signal and no packet loss. The laptop still shows nothing. La!
ptop cant ping AP either. Any thoughts or ideas. This is the latest version by
the way.
Thanks,
--
Eric L. Johnson
WarpSpeed Internet
1-361-563-3742
--
|