Bob,
I happen to run two PCs: one running CT Version 10 on DOS and the other
running CTWin Version 10 on Windows 98. I also use CVB with a homebrew
interface that uses the LPT output for keying the radio. With Version
10, LPT doesn't work with either the DOS or Win98 PC!! Going back to CT
Version 9 works just fine.
Gerry, W1GD
-----Original Message-----
From: ct-user-bounces@contesting.com
[mailto:ct-user-bounces@contesting.com] On Behalf Of Bob Schreibmaier
Sent: Thursday, March 03, 2005 10:41 PM
To: ct-user@contesting.com
Subject: [ct-user] CT-MFJ 434
One caution, make sure you're using CT-DOS.
CTWin doesn't appear to support voice keying
from the LPT port.
>What do you mean by this? Do you want to key it from CT?
>
>There is a schematic on page 14 of the manual. Setup CT to use one of
the LPT ports, making sure that it is configured properly (like ECP).
Pins 3,4,5, &6 correspond to messages F1, F2, F3, F4. Output of the
parallel port is 5V positive going. Ground is 11. One problem you will
have to solve is that the STOP function in the 434 is a separate button.
On the DVP card it is ESC. You will find that you will only get 3
messages out of this setup, having to probably dedicate one F button to
STOP.
>
>At 3/3/2005 07:14 PM, stanley elkins wrote:
>>I would like to use a MFJ 434 Voice keyer with CT.
>>Has anyone used this setup and how is it done
>>Any help would be appreciated
--
+----------------------------------------------+
| Bob Schreibmaier K3PH | E-mail: k3ph@ptd.net |
| Kresgeville, PA 18333 | http://www.dxis.org |
+----------------------------------------------+
_______________________________________________
CT-User mailing list
CT-User@contesting.com
http://lists.contesting.com/mailman/listinfo/ct-user
CT on the web: http://www.k1ea.com/
_______________________________________________
CT-User mailing list
CT-User@contesting.com
http://lists.contesting.com/mailman/listinfo/ct-user
CT on the web: http://www.k1ea.com/
|