Hi David,
Thanks for the response.
This is my first attempt. Running 5 watts into a dummy load.
Wiring looks good. Single dits and dahs work okay. Putting
them together creates garbage, after the initial good first
letter. Tried Super CMOS, Curtis A, and Curtis B modes with
no difference. Tried two different paddles with no difference.
Was thinking about performing an exorcism. 8^)
73,
Bob
----- Original Message -----
From: "David Robbins K1TTT" <k1ttt@arrl.net>
To: "reflector ct-user" <ct-user@contesting.com>
Sent: Thursday, June 26, 2003 4:20 PM
Subject: RE: [ct-user] CT 9.90.007 and Paddle
> Check that you aren't getting rf into the port... turn off or reduce
> radio power. Doublecheck wiring and pin numbers, make sure no pins are
> shorted and that pullup resistors are properly connected. Slow the
> speed way down and try to send single dits and dahs to see if maybe you
> have bounce in a paddle contact. Has it worked with earlier versions on
> that machine or is this your first attempt??
>
>
> David Robbins K1TTT
> e-mail: mailto:k1ttt@arrl.net
> web: http://www.k1ttt.net
> AR-Cluster node: 145.69MHz or telnet://dxc.k1ttt.net
>
>
> > -----Original Message-----
> > From: ct-user-bounces@contesting.com [mailto:ct-user-
> > bounces@contesting.com] On Behalf Of Bob Schreibmaier
> > Sent: Thursday, June 26, 2003 20:00
> > To: ct-user@contesting.com
> > Subject: [ct-user] CT 9.90.007 and Paddle
> >
> > I tried to use CT 9.90.007 and an external paddle on
> > a Toshiba 486/50 laptop (QRP Field Day computer)
> > running MS-DOS 6.22. I used the REVPADDLE command
> > to get the left paddle to send dits and the right
> > to send dahs.
> >
> > Sending with the motion necessary to send a "V",
> > the first letter out is a "V", but the next one is an
> > "F", followed by something unintelligible.
> >
> > I've tried not using REVPADDLE, but simply changing
> > the paddle around. Same results.
> >
> > Has anyone else seen this behavior? Is it possible
> > to fix?
> >
> > TIA.
> >
> > 73,
> > ____ / _____ /
> > / ) / / /
> > /____/ ____ /___ (____ ____ /___ /___
> > / ) / ) / ) ) / / ) /
> > /_____/ /____/ /____/ _____/ (____ / / / . . .
> >
> > +---------------------------------------------------+
> > | Bob Schreibmaier K3PH | E-mail: k3ph@ptd.net |
> > | Kresgeville, PA 18333 | http://home.ptd.net/~k3ph |
> > +---------------------------------------------------+
> >
> > _______________________________________________
> > CT-User mailing list
> > CT-User@contesting.com
> > http://lists.contesting.com/mailman/listinfo/ct-user
>
>
>
> _______________________________________________
> CT-User mailing list
> CT-User@contesting.com
> http://lists.contesting.com/mailman/listinfo/ct-user
>
|