Joe,
You will need to get the Kenwood IF-232C Level translator. This device will
interface your radio to one of the computer's COM ports. You may have to
configure the radio's menu to open the port to the radio. Refer to your
TS-450 manual.
The KAM works with CT as a regular TNC. When you set this up you will lose
the dual port capability while running under CT.
Read the CT manual as to initial setup and all will become clear.
Tom KA2D
----- Original Message -----
From: <N1KRT@aol.com>
To: <ct-user@contesting.com>
Sent: Tuesday, October 17, 2000 9:36 PM
Subject: [ct-user] help
>
> I need help . Just recently purchased ct , trying to connect my computer
to
> my Kenwood TS 450. DO I need some type of interface ? I also have a Kam
> Plus Tnc and would like to use this to utilize the packet cluster. Since
I'm
> not your basic computer genius I would appreciate some info.. TANX
>
> Joe Pardo N1KRT
N1KRT@aol.com
>
> --
> WWW: http://www.k1ea.com/
> Submissions: ct-user@contesting.com
> Administrative requests: ct-user-REQUEST@contesting.com
> Problems: owner-ct-user@contesting.com
>
>
--
WWW: http://www.k1ea.com/
Submissions: ct-user@contesting.com
Administrative requests: ct-user-REQUEST@contesting.com
Problems: owner-ct-user@contesting.com
|