I downloaded CT Ver. 9.48--the latest available from ctvault--and tried to
use my new W1WEF keying interfacing with my IC-765 this weekend. My older
com2 interface worked fine, but I could not key through my printer port with
the W1WEF Interface.
The radio behaves the same way it does with the serial interface when I plug
in the printer port interface, i.e. the radio goes key down. Normally, when
I start CT and hit any function key that sends, the key down condition ends
and the radio keys properly. When I hit a function key with the W1WEF CW
Interface plugged in instead of the serial port interface and hit a function
key, the radio remains key down. (No CW is sent.)
Of course, I specified "LPT1" in the CT setup. I tried both ARRL DX CW and
CQWW CW with the same results.
The computer is a 486/20 Mhz machine booted to DOS.
Any suggestions?
73,
Frank
WB2BXO
--
Submissions: ct-user@contesting.com
Administrative requests: ct-user-REQUEST@contesting.com
WWW: http://www.k1ea.com/
Questions: owner-ct-user@contesting.com
|