Make sure that you dont have your dial set to MTUNE rather than VFO. It wont
work unless you do, and when you do a hard reset guess what? It comes up in
VFO mode and is magically fixed! hi!
73, Ty K3MM
-----Original Message-----
From: wb6tza@compuall.net <wb6tza@compuall.net>
To: ct-user@contesting.com <ct-user@contesting.com>
To: <ct-user@contesting.com>
Date: Thursday, May 28, 1998 21:40
Subject: [ct-user] ft-1000mp comm problems
>re the loss of meaningful comm ft-1000mp and CT
>
>We found that the comm errors occurred with straight dos, and no tnc or
>network involved, used CT-9.27, and laptops, so the AC power/groundloops
>wasn't an issue. The evidence was that the 1000 itself was the problem.. 3
>of the 4 radios required a cpu reset on arrival in XZ, and one of those
>required another reset when we returned. Seems probable the NV ram can get
>some junk stored, confusing the issue.
>
>suggest you reset the cpu in the 1000 and try again- see the manual, you
>will have to re-load whatever you have changed in the menus.
>
>this is much like ctl/alt/del in a PC - it re-reads most stuff and seems
>to run better
>
>
>robin critchell, wa6cdr, xz1n, n6ll
>
>
>--
>Submissions: ct-user@contesting.com
>Administrative requests: ct-user-REQUEST@contesting.com
>WWW: http://www.contesting.com/ct/
>Questions: owner-ct-user@contesting.com
>
--
Submissions: ct-user@contesting.com
Administrative requests: ct-user-REQUEST@contesting.com
WWW: http://www.contesting.com/ct/
Questions: owner-ct-user@contesting.com
|