another thing to check is that you aren't using a memory to tune with.
ct will only read the vfo frequencies it will not detect that you
are in mtune mode. band changes will still work, but ct will read
the vfo frequency even after it changes the band in the memory mode.
Pawel SP7NMW wrote:
>
> I need a help with CT and FT-1000MP configuration and changing bands.
>
> I can change the bands of my transceiver from the keyboard (alt-F1, alt-F-2)
> but when I want to log in QSO by ENTER there is: "Out of band! 18075300"
> information on the bottom of the screen (I was on the 21.005). I tried
> several times and still the same.
>
> Let me show the steps I make with computer and CT:
>
> 1. First I turn on FT-1000 MP.
> 2. Next start my computer with Win 95, when it is loaded I close it and start
> DOS.
> 3. I load TSR and start CT, make all configurations. Changing bands works,
> but I can't log QSOs.
>
> I have checked the "com" configuration and have the following ports:
> a. com 1 - irq 10 (I switch it manually from 4 - it was conflict with com 3)
> b. com 2 - irq 05 (it was 3 and conflict with com 4)
> c. com 3 - irq 4 (I can not change it)
> d. com 4 - irq 3
>
> The same results I have if I start my computer without Win 95 by pressing F8
> and do not load Win 95.
> I also tried with computer configured with the same IRQ on two ports, as was
> at the original configuration of my computer.
>
> I hope you will help.
>
> See you in the WPX.
>
> Paul, SP7NMW
>
> --
> Submissions: ct-user@contesting.com
> Administrative requests: ct-user-REQUEST@contesting.com
> WWW: http://www.contesting.com/ct/
> Questions: owner-ct-user@contesting.com
--
David Robbins K1TTT (ex KY1H)
k1ttt@berkshire.net or robbins@berkshire.net
http://www.berkshire.net/~robbins/k1ttt.html
--
Submissions: ct-user@contesting.com
Administrative requests: ct-user-REQUEST@contesting.com
WWW: http://www.contesting.com/ct/
Questions: owner-ct-user@contesting.com
|