I've got Charter Cable and an Asus AC-1900 router. I've having a similar
problem Scott. Anything over X power and on Y frequency on 160m causes the
modem to stall. I had Charter send out a new tech who I had a nice conversation
with about what was happening. He installed new cable with me from my box as he
was able to justify their expense considering his tested signal strengths.
That helped...
I replaced all network cables in my house with Cat 7 which helped some too.
Installing type 31 beads on the network cables and RG6 helped some. I only had
one type 31 toroid on hand (ordering more for many other uses too) and that
went on the modem's power cable with tons of turns.
What I've found is the following:
With my tower only 40' from my router/modem and the 160m inverted-L horizontal
run passing directly overhead some 20' above... I can run nearly legal limit at
1.825 mhz without issue, but I can only run X hundreds of watts on as the
frequency goes up (starting around 1.835) before the modem stalls.
I need to call again to get a new modem as they asked I try out their new cable
install for a while.
I'll also order more type 31 toroids and longer Cat7 cables to make numerous
turns as per Jim's cookbook after that if I still am having similar problems.
Tim / N6WIN
On Thursday, August 23, 2018, 11:53:51 AM PDT, Jim Brown
<k9yc@audiosystemsgroup.com> wrote:
Hi Scott,
What kind of internet connection? DSL modems are notoriously poor at
rejecting RF, and 160M is within the range of their data signal. Part of
the problem is telco wiring around your home -- replacing it with high
quality twisted pair data cable like CAT5/6 can help. But when their
modem is the problem, the best solution is to call your provider and
tell them to fix it. W8JI did that years ago.
Have you considered WiFi for networking? That significantly reduces RF
related issues, including internet birdies on the ham bands. I started
replacing wired Ethernet with WiFi when I lived in Chicago, and am doing
the same here in NorCal.
As to ferrites -- it takes a LOT of turns through one or more #31 cores
to make an effective choke for 160M. If you haven't already done so,
study k9yc.com/RFI-Ham.pdf
73, Jim K9YC
On 8/23/2018 7:50 AM, K9MA wrote:
> Despite a ton of ferrite cores on all the cables, my router fails every
> time I transmit on 160. I'll admit that RF levels are high, as my
> shunt-fed tower is only about 20 meters away from the router, and some
> of the ethernet cables come within about 10 meters of the tower. Has
> anyone found a router that doesn't have this problem?
>
> 73,
>
> Scott K9MA
>
_______________________________________________
CQ-Contest mailing list
CQ-Contest@contesting.com
http://lists.contesting.com/mailman/listinfo/cq-contest
_______________________________________________
CQ-Contest mailing list
CQ-Contest@contesting.com
http://lists.contesting.com/mailman/listinfo/cq-contest
|