In my FT5000 everything works ok. The only problem is the signal level is too
low, so I have to use the additional 10dB audio amplifier to have good signal
for the recording. Yaesu must do regulated output like in Elecraft K-3
73! Andy UA3DPX
Отправлено с iPad
> 5 марта 2017 г., в 7:01, Trent Sampson <vk4ts@outlook.com> написал(а):
>
> All this recording talk has made me revisit the shack configuration.
>
>
> After testing the FT2000 FT950 I can get the RX audio out of the RECORD Jack
> on the rear panel but no transmit audio on any modes
>
>
> The Manual(s) says to set monitor to on - but there is no difference -
>
>
> Modes will be SSB RTTY and CW.
>
>
> Has anyone successfully done this or do I need to try some other point?
>
>
> My issue is the FT5000 rigs are at a remote site and really want to be able
> to sort this out prior to the 4 hour round trip to the remote.
>
>
> Thanks in advance.
>
>
> Regards
>
> Trent
> VK4TS
> PO Box 275
> Mooloolaba 4557
> 0408497550
>
> _______________________________________________
> CQ-Contest mailing list
> CQ-Contest@contesting.com
> http://lists.contesting.com/mailman/listinfo/cq-contest
_______________________________________________
CQ-Contest mailing list
CQ-Contest@contesting.com
http://lists.contesting.com/mailman/listinfo/cq-contest
|