CQ-Contest
[Top] [All Lists]

Re: [CQ-Contest] Will a Ham IV Rotator fit inside a Rohn 25 tower tip se

To: cq-contest@contesting.com
Subject: Re: [CQ-Contest] Will a Ham IV Rotator fit inside a Rohn 25 tower tip section ?
From: Mike <nf4l@nf4l.com>
Reply-to: nf4l@nf4l.com
Date: Wed, 03 Nov 2010 07:34:11 -0400
List-post: <cq-contest@contesting.com">mailto:cq-contest@contesting.com>
AG denotes the tapered top section, and there are 5 styles listed in the Rohn 
catalog. Different configurations of the mast tube. The Ham IV fits inside just 
fine. 
Unless you want to cut a Z brace, however, it needs to go in before the section 
goes up.

73, Mike NF4L

On 11/2/2010 5:09 PM, Dennis Vernacchia wrote:
> A friend e-mailed me that he has a 25AG section
>
> I used to recall Rohn 25G
>
> not a clue what an AG nomenclature means and if that means a Ham IV will fit
> inside section ?
>
> 73. Dennis
> _______________________________________________
> CQ-Contest mailing list
> CQ-Contest@contesting.com
> http://lists.contesting.com/mailman/listinfo/cq-contest
>


_______________________________________________
CQ-Contest mailing list
CQ-Contest@contesting.com
http://lists.contesting.com/mailman/listinfo/cq-contest

<Prev in Thread] Current Thread [Next in Thread>