CQ-Contest
[Top] [All Lists]

Re: [CQ-Contest] Will a Ham IV Rotator fit inside a Rohn 25 tower tip se

To: "CQ-Contest\"; \"towertalk" <cq-contest@contesting.com>
Subject: Re: [CQ-Contest] Will a Ham IV Rotator fit inside a Rohn 25 tower tip section ?
From: Mike&Shelley Ritz <micritz@comcast.net>
Date: Wed, 3 Nov 2010 16:46:26 +0000 (UTC)
List-post: <cq-contest@contesting.com">mailto:cq-contest@contesting.com>
Dennis; 

The Rohn 25AG is the special 9 foot tapered top section for standard Rohn 25 
tower, and yes, with the proper rotator shelf plate the Ham IV will fit just 
fine. I think Rohn 25 is about a foot on a side.... 

73; 

Mike, W7VO 
Scappose , OR 


----- Original Message ----- 
From: "Dennis Vernacchia " <n6ki73@ gmail .com> 
To: " towertalk " < towertalk @contesting.com> 
Cc: "CQ-Contest" <cq-contest@contesting.com> 
Sent: Tuesday, November 2, 2010 2:09:31 PM 
Subject: [CQ-Contest] Will a Ham IV Rotator fit inside a Rohn 25 tower tip 
section ? 

A friend e-mailed me that he has a 25AG section 

I used to recall Rohn 25G 

not a clue what an AG nomenclature means and if that means a Ham IV will fit 
inside section ? 

73. Dennis 
_______________________________________________ 
CQ-Contest mailing list 
CQ-Contest@contesting.com 
http ://lists.contesting.com/mailman/ listinfo /cq-contest 
_______________________________________________
CQ-Contest mailing list
CQ-Contest@contesting.com
http://lists.contesting.com/mailman/listinfo/cq-contest

<Prev in Thread] Current Thread [Next in Thread>