On telrex the other element joints were usually secured by a screw through
pre-drilled holes so there was only one possible adjustment on the elements
at the tip.
David Robbins K1TTT
e-mail: mailto:k1ttt@arrl.net
web: http://www.k1ttt.net
AR-Cluster node: 145.69MHz or telnet://dxc.k1ttt.net
> -----Original Message-----
> From: cq-contest-bounces@contesting.com [mailto:cq-contest-
> bounces@contesting.com] On Behalf Of Paul Cassel
> Sent: Sunday, July 01, 2007 13:48
> To: cq-contest@contesting.com
> Cc: 'Paul VE3SY'
> Subject: [CQ-Contest] Seeking mono-band Telrex info
>
> I'm in the process of replacing my 3 element Hy-gain mono-banders with the
> 5
> element 15M532 on 15 and 10M5325 on 10. The 20 m is 4 elements however I
> have no manual and am unsure of the model number.
>
> We have successfully re-assembled the 10 and 15m antennas however the
> manual
> only shows measurements for the tip section. Since the 15 and 20 m models
> have multiple sections in each element, the tip measurements alone does
> not
> make much sense as the other sections have quite a range of overlap.
>
> Does anyone out there have center of boom to tip measurements for these
> antennas? I would also appreciate a copy of the 4 element manual for
> same.
>
>
> Thanks everyone
>
> Paul VE3SY
>
>
>
> _______________________________________________
> CQ-Contest mailing list
> CQ-Contest@contesting.com
> http://lists.contesting.com/mailman/listinfo/cq-contest
_______________________________________________
CQ-Contest mailing list
CQ-Contest@contesting.com
http://lists.contesting.com/mailman/listinfo/cq-contest
|