CQ-Contest
[Top] [All Lists]

Re: [CQ-Contest] dsl rf filter

To: reflector cq-contest <CQ-Contest@Contesting.COM>
Subject: Re: [CQ-Contest] dsl rf filter
From: N6KI Dennis Vernacchia <n6ki_73@sbcglobal.net>
Date: Sun, 19 Nov 2006 01:20:28 -0800
List-post: <mailto:cq-contest@contesting.com>
I am using -31 mix Ferrite on all my DSL connections and seems to work 
fine to stop RFI

Mouser Electronics has some FAIR-RITE snap on ones that also may snap on 
RG-213 coax
tightly in case you also want to build current Baluns

Mouser Part #:, 623-*0431167281  less than $2 ea*


Also 2.4 inch Donuts from DEXTER MAGNETIC TECHNOLOGIES
800/775-3829 877/221-5052

Fair Rite Part Number 2631626402

I have been buying these at $3 in 100 quantity but
see what they are in small QTY


73, Dennis N6KI

David Robbins K1TTT wrote:
> I recently switched from isdn to dsl, which of course meant a new round of
> rf filtering for the new dsl modem/router.  Ferrites on the power and phone
> line did pretty good, but not quite enough for the low 80m V and low 40m
> beam, both of which kind of aim through the phone line and aren't that far
> from the shack.  While picking up some capacitors to build my own line
> filter at, of all places, radio shack, the clerk actually came up with an
> interesting product.  They have a 3-30mhz rf line filter for 2 line phones.
> (279-151).  Its basically a balanced LC lowpass filter.  At normal home dsl
> speeds it worked fine right out of the bubble pack, I only know this because
> for about 3 weeks my isp was fighting with verizon trying to get me up to
> the 3mb business line speed.  When they finally got the speed up to where it
> belonged the line loss from the filter was too high.  For those who don't
> know about dsl it uses frequencies up to about 500khz.  So I adjusted the
> filter a bit by removing the 4 inductors for the 2nd line and putting them
> in parallel with the 4 for the line I was using, this should effectively
> reduce the inductance and shift the passband up a bit higher... this seems
> to be working, it still has a bit more loss than I would like, but does
> effectively block 80m and 40m.
>
>
> David Robbins K1TTT
> e-mail: mailto:k1ttt@arrl.net
> web: http://www.k1ttt.net
> AR-Cluster node: 145.69MHz or telnet://dxc.k1ttt.net
>  
>
>
> _______________________________________________
> CQ-Contest mailing list
> CQ-Contest@contesting.com
> http://lists.contesting.com/mailman/listinfo/cq-contest
>
>   
_______________________________________________
CQ-Contest mailing list
CQ-Contest@contesting.com
http://lists.contesting.com/mailman/listinfo/cq-contest

<Prev in Thread] Current Thread [Next in Thread>