To: | n5nj@gte.net, Dave Hachadorian <k6ll@juno.com>,<cq-contest@contesting.com> |
---|---|
Subject: | Re: Re: [CQ-Contest] Contesting Computer |
From: | "David A. Pruett" <k8cc@comcast.net> |
Date: | Tue, 25 Nov 2003 18:35:48 -0500 |
List-post: | <mailto:cq-contest@contesting.com> |
At 09:48 AM 11/25/03 -0600, Bob Naumann - N5NJ wrote:
>>Motherboard must have one ISA slot. It can still be done. Byterunner 4 com port ISA Board, uses one shared IRQ. I was going to make this comment, but Bob took care of it. We ran into this with our recent CQWW SSB trip to VE1JF, where we took a pair of small Acer P-233 desktops for logging. These computers have only one serial port, one ISA slot and one PCI slot. Since this was a phone contest, we wanted to use the ISA slot for the W9XT Contest Card voice keyers. For some time, I've had these computers equipped with a SiiG single COM PCI card in the PCI slot. While these are PnP (plug-and-play) cards, SiiG provides a utility which you launch in AUTOEXEC.BAT which sets up the card. These work perfectly under DOS using IRQ11. The problem comes when you need two COM ports, like we needed at VE1JF (the third COM to feed spots into from WinTelNetX). I mail-ordered a dual COM SiiG card, which set up just like my single COM card, and it indeed worked fine under DOS *as long as you only ran one COM port*. Reading the docs revealed that the single IRQ was shared between the COM ports. No amount of fiddling on my part could make both COM ports work. I searched the web pretty thoroughly for a PCI dual COM card, and every single one that I could find shares an IRQ. I finally gave up and dug thru my assortment of old expansion cards and found an old ISA card that I could address as COM 3 & 4 with unique IRQs, but then we had to resort to an outboard voice keyer. Sharing IRQs is usually no problem while running PnP cards under Windows, so most any Windows logging program should be set. Under DOS, it's a different matter. CT and NA both require unique IRQs for each COM port. I believe TRLog is different - the last time I talked to Tree about it, he said TRLog "polls" the COM ports and hence require no IRQ at all. In almost any case I can think of, if the program does not use an IRQ for the COM port, then sharing them is not an issue. YMMV 73, Dave/K8CC
_______________________________________________ CQ-Contest mailing list CQ-Contest@contesting.com http://lists.contesting.com/mailman/listinfo/cq-contest |
<Prev in Thread] | Current Thread | [Next in Thread> |
---|---|---|
|
Previous by Date: | Re: [CQ-Contest] SS from KP4 (or WP3), Steve London |
---|---|
Next by Date: | Re: [CQ-Contest] What callsign to use in CQ WW CW 2003?, Gerry Treas, K8GT |
Previous by Thread: | Re: [CQ-Contest] Contesting Computer, K4SB |
Next by Thread: | [CQ-Contest] NP4Z's SS comments etc., RICHARD BOYD |
Indexes: | [Date] [Thread] [Top] [All Lists] |