As all multiop contest veterans know, it can be a big challenge
to keep local transmitters on other bands out of your receiver.
A bigger challenge is keeping transmitters on the same band
from making it impossible to hear anything. Probably the most
prominent case in which this is a problem is Field Day.
Several band-pass filter construction articles have been published
over the years (notably by K4VX and W3LPL), and some commercial
products for this application are available. However, I haven't
seen any that address cases of interference within a few hundred
kilohertz. Intuitively, it seems that a very-high-Q notch filter
and a band-pass filter at the receiver could solve this problem.
Perhaps the opposite configuration at each transmitter would also
be necessary.
Have you seen anything published or sold that address this problem?
If so, please email me.
--73, Rus
____________________________________________________________________
Rus Healy, NJ2L rhealy@arrl.org
Senior Assistant Technical Editor, QST Tel 203-666-1541
ARRL, 225 Main St, Newington CT 06111-1494 Fax 203-665-7531
1.8 through 3456 MHz -- and climbing!
|