Amps
[Top] [All Lists]

Re: [Amps] step start

To: amps@contesting.com
Subject: Re: [Amps] step start
From: Val <val@vip.bg>
Date: Mon, 2 Oct 2023 21:21:28 +0300
List-post: <mailto:amps@contesting.com>
Hello Paul,

As you will put the step start circuit in the transformer primary, it will limit the transformer inrush current and thus all the voltages provided by the transformer - filament, screen, grid, plate.

73, Val LZ1VB


На 01-10-23 в 21:19, Paul Decker написа:
Hello all.

I'm building a 4cx1500b amplifier. This is the first tetrode high power 
amplifier I've tried to do.  I'm using about 300V on the screen and 2500 on the 
plate.

For my power supply I'm using a 1 Henry choke input on the screen supply 
dumping into 200uF This seems pretty stiff.  For the plate supply it's a 
voltage doubler outputting 2700 V dumping into 93uF.  Not quite as stiff, about 
300V drop under full load. I have plenty of capacitors, so I can add more 
capacitance if needed.

Two questions,
1. is the plate voltage regulated enough or do I need more plate regulation and
2. for soft start,  Should the soft start bring both the screen voltage and 
plate voltage up or should I let the screen voltage be and just soft start the 
plate voltage.

Thanks for any insights you all might have.

Paul
KG7HF

_______________________________________________
Amps mailing list
Amps@contesting.com
http://lists.contesting.com/mailman/listinfo/amps

_______________________________________________
Amps mailing list
Amps@contesting.com
http://lists.contesting.com/mailman/listinfo/amps
<Prev in Thread] Current Thread [Next in Thread>