10 kw CCS on 6M..using the 3CX-6000A7.
Ok, here's the 3rd installment of this project.
Here, the socket and chimney are installed. Due to space constraints, the
tube is in the corner. To get around piling on more stray C ..between side
/ rear wall..and anode, I had him space the anode 2.5" away from both. When
the space is say doubled, the C will drop to just 1/4. Same deal with
spacing between stator + rotor plates on an air variable.
Also note, instead of using machine screws to mount the .515" thick chimney
to the chassis...threaded studs were used instead. Studs screwed into the
teflon. Then chimney + studs dropped onto chassis. It's another way of
doing it. If mounting the chimney to the top lid, it's actually much
quicker using the studs.
https://www.youtube.com/watch?v=RBIT76-o6tM
<https://www.youtube.com/watch?v=RBIT76-o6tM&fbclid=IwAR10CtUWkUQ-LTRBvq6StAPbI2dhthPZTW5815ahAeuSY2t3I0ki02JF0vQ>
_______________________________________________
Amps mailing list
Amps@contesting.com
http://lists.contesting.com/mailman/listinfo/amps
|