Larry, do you have a complete circuit diagram of your homebrew HV power supply?
If so, you should check and see if the power supply has a B- current return,
as opposed to a simple chassis ground connection. In my experience, many old
timers didn’t understand the reason for routing the return current through B-,
which should be kept separate from chassis ground. Drake amplifiers require an
independent B- return. Without it, the amplifier bias and metering circuits
won’t work properly. There is no easy fix for this, other than rebuilding the
power supply and changing its circuitry. It’s not a hard conversion, but it
requires an understanding of the nuances of the power supply and L4B metering
and bias circuitry.
73,
Jim W8ZR
Sent from Mail for Windows
From: A Lawrence Fibich
Sent: Monday, January 17, 2022 9:58 PM
To: Mickey Baker
Cc: amps@contesting.com
Subject: Re: [Amps] Drake L-7 amplifier power supply requirements
Thanks Mickey but I have them. The difficulty is trying to connect this home
brew power supply to what the amp needs. HV no problem; as well as 120vac via
the in/ off switch but the rest of the pins into the amp are the puzzles. I
charted all the output from this ps but it is unlike the original Drake ps But
thanks for your help73Larry FW6EF(916) 966-0266
Sent from AT&T Yahoo Mail for iPhone
On Monday, January 17, 2022, 8:30 PM, Mickey Baker <n4mb@arrl.net> wrote:
Larry,
You’ll find a manual and a schematic here:
https://bama.edebris.com/manuals/drake/l7/
Hope that helps.
73,
Mickey Baker N4MBPalm Beach Gardens, FL
On Sat, Jan 15, 2022 at 1:24 PM A Lawrence Fibich <lfibich@sbcglobal.net> wrote:
I could use assistance from anyone who knows this Drake Amplifier and it's
power supply. 1st I have advertized widely for an original one to buy -
nothing.2ndly I did get a 'home built' power supply but at a road block as how
to connect parts of it. The HV section OK, and a secondary transformer
provides a 120VAC to run through the on/off switch of the Amp to work the
finals heaters circuit. But I come to 'stop' in trying to know/figure out what
more it needs into the circuits to the right of the finals on the schematic -
like the interlock, ALC, meter, etc. This homebuilt power supply does put out
5 VAC on the secondary but I don't know how to connect that to the Amp.Any
assistance really appreciated.
73Larry FW6EFFair Oaks, CA (Sub of Sacramento, CA)
_______________________________________________
Amps mailing list
Amps@contesting.com
http://lists.contesting.com/mailman/listinfo/amps
--
“Ends and beginnings—there are no such things. There are only middles.” Robert
Frost
_______________________________________________
Amps mailing list
Amps@contesting.com
http://lists.contesting.com/mailman/listinfo/amps
_______________________________________________
Amps mailing list
Amps@contesting.com
http://lists.contesting.com/mailman/listinfo/amps
|