The amp should not pull any plate current in standby. If it does, you either
have a shorted tube or a shorted pass transistor in the bias circuit which is
common in that amp. A good tube arc will cause that.
Sent from AOL Mobile Mail
Get the new AOL app: mail.mobile.aol.com
On Monday, December 9, 2019, Terry's ham <k7ny@live.com> wrote:
I forgot I pulled the input relay and it was fine. It draws current in standby
or operate.
_______________________________________________
Amps mailing list
Amps@contesting.com
http://lists.contesting.com/mailman/listinfo/amps
_______________________________________________
Amps mailing list
Amps@contesting.com
http://lists.contesting.com/mailman/listinfo/amps
|