Will placing choke in the ground return work with a swing choke input
resonant choke supply like this? don't know the answer, just asking and may
be remembering wrong about the supply configuration. I vaguely remember
considering moving it but wondered also about the metering.
Dave W7VM
On Fri, Sep 27, 2019 at 10:44 AM jeff millar <wa1hco@gmail.com> wrote:
> Hi Ron,
>
> I like the idea of putting the choke in the return lead. But the way the
> return floats a bit above ground for metering makes me uncertain exactly
> where to wire in choke.
>
> - between bridge and resistors to ground, or...
> - between resistors to ground and filter capacitor returns
>
> thanks,
>
> jeff, wa1hco
>
> On Thu, Sep 26, 2019 at 10:59 PM Ron <ka4inm@gmail.com> wrote:
>
> > Jeff wa1hco millar wrote:
> >
> > > Hello wise ones...
> >
> > > Bought a nice 3K-A at a flea market and made one SSB contact. On the
> > > second contact it tripped off on HV overcurrent. After some debugging,
> > the
> > > Plate choke is leaky to ground at HV but open with an Ohm meter.
> > > Can I just put the choke up on insulated standoffs?
> >
> > > Any other suggestions?
> >
> > It is a pleasure to be helpful.
> >
> > The CURE is to put it in the ground side of the circuit, typically
> > where the rectifier or the grounded side of the transformer goes to
> > ground.
> >
> > --
> > Ron KA4INM - Understanding is much better than
> > knowing how.
> > _______________________________________________
> > Amps mailing list
> > Amps@contesting.com
> > http://lists.contesting.com/mailman/listinfo/amps
> >
> _______________________________________________
> Amps mailing list
> Amps@contesting.com
> http://lists.contesting.com/mailman/listinfo/amps
>
_______________________________________________
Amps mailing list
Amps@contesting.com
http://lists.contesting.com/mailman/listinfo/amps
|