Harwin H3161-05. Intended for 2mm mounting hole so might be usable with
a bit of ingenuity. Get them from Mouser or Farnell.
Steve
On 05/07/17 16:52, Steve wrote:
I made a homebrew socket that way many years ago. I'm fairly sure the
pin size was 1.0mm. I got some sockets which were open both ends so the
exact length wasn't important. I'll try to find the leftovers for the
p/n, I'm fairly sure they were from Harwin.
BTW, the screen ring from a dismantled 4CX250 base fits the 3CX800 grid
ring a treat.
Steve
On it's way to me from a faraway land is a PCB that is designed to be
part of a socket for a 3CX800. It has 2.5mm clearance plated through
holes. I need some solder in pins to make it into a working socket. I
do not know the diameter of the 3CX800 pins, I assume that such pins
must exist or the PCB would never have been produced in the first
place. Could someone point me to some suitable solder in pins with a
2.5mm outside diameter and a hole suitable for a snug fit to the
3CX800 pins?
Failing that the diameter of the tube pins would suffice. Yes I have a
tube in an amplifier and yes I can measure it myself but I am sure
someone will already know the answer to this and it saves me
dismantling it until I am really ready :-)
Regards
Conrad PA5Y
_______________________________________________
Amps mailing list
Amps@contesting.com
http://lists.contesting.com/mailman/listinfo/amps
|