Ron,
Thanks for the reply!
On Jul 4, 2017, at 3:51 PM, Ron Youvan <ka4inm@gmail.com> wrote:
Warren Volz wrote:
Thank you for the replies. I had some time to circle back to this today and
checked a few things.
- With the tubes removed, it looks like they have no shorts but the grids measure ~0
ohms (maybe it’s too low for my meter?). Is that expected?
- Checking the filament transformer I see (All are while in circuit with the
power switch off)
BLK-BLK/YEL = 3.2 ohms
BLK/GRN-BLK/RED = 4.1 ohms
RED-RED = 10 ohms
GRN-GRN = 0 ohms
GRN/YEL-GRN = 0 ohms
Tube pins 2, 3 & 4 should all measure zero Ohms in any direction.
Correct, they are zero Ohm (after the meter settles) in any direction.
Am I correct in assuming that 0 ohms across the GRN/GRN winding is not
a good sign?
- Checking the anode to chassis resistance without tubes and the HV interlock
defeated I see ~750 Kohm, is this normal?
Zero Ohms is a good reading across a 5 Volt 30 Ampere transformer
winding.
When I rebuilt this, I did the following modifications:
- W7RY board with fuse option installed
- ES4SB220 filter capacitor board installed with new electrolytics
- RM220 replacement metering board installed
- Grids grounded
- Molex connector on the HV transformer primary windings
As I mentioned previously I think the fan isn’t working, but I haven’t had a chance to
verify that yet. I only have one more replacement set of fuses so I’m trying to be smart
about my testing until I can get replacements (likely later this week). I can easily disconnect the
HV transformer. Am I correct in assuming that if the fuses blow after disconnecting the hV primary I
can assume the filament transformer is bad?
Thanks again for your help!
You do not say if the filaments light or start to light when you turn
on the power. You do not say if you have the unit in the high power or
low power mode.
I do not know anything about the step start circuit, but it is suspect.
When I had the fuses blow the meter lights did not turn on, but I can’t comment
on the filaments. I was being a little paranoid and was several feet away when I first
turned it on. Unit was in the low power mode when I tried it before.
-Warren
_______________________________________________
Amps mailing list
Amps@contesting.com
http://lists.contesting.com/mailman/listinfo/amps