w6plq.com
Look in the "Parts I can supply" link on his page. Milled and drilled
for the device and the heat sink.
He will flow solder, (recommended install method by Freescale and NXP)
the device to the spreader if you desire.
On 8/12/2016 2:52 PM, Ian Swain wrote:
Hi guys I'm building my first ldmos amp with a blf188xr and can't find a
nice think slab of copper for a heat spreader
I've only found up to 6mm think would this be okay ? Or could I get away
with 2 layers to get 12 mm with heat transfer paste ?
Any other zl stations or vk found a good copper source ?
73 de zl2ias
All the best
_______________________________________________
Amps mailing list
Amps@contesting.com
http://lists.contesting.com/mailman/listinfo/amps
--
R. Kevin Stover
AC0H
ARRL
FISTS #11993
SKCC #215
NAQCC #3441
---
This email has been checked for viruses by Avast antivirus software.
https://www.avast.com/antivirus
_______________________________________________
Amps mailing list
Amps@contesting.com
http://lists.contesting.com/mailman/listinfo/amps
|