| To: | amps@contesting.com |
|---|---|
| Subject: | [Amps] Amp Supply LK-500ZB Plate current meter and circuit |
| From: | Charles K Hardy via Amps <amps@contesting.com> |
| Reply-to: | Charles K Hardy <k5sul@aol.com> |
| Date: | Wed, 2 Sep 2015 18:24:28 -0400 |
| List-post: | <amps@contesting.com">mailto:amps@contesting.com> |
Plate current meter stopped working but checks out to be okay. Diodes across the meter are not shorted and the shunt resistor appears to be okay as well. Found two resistors in parallel, a 510 ohm and 1000 ohm, connected in series to the positive meter wire at the meter. I don't think this is original and it is not on theschematic. Any help would be appreciated. Charles K5SUL _______________________________________________ Amps mailing list Amps@contesting.com http://lists.contesting.com/mailman/listinfo/amps |
| <Prev in Thread] | Current Thread | [Next in Thread> |
|---|---|---|
| ||
| Previous by Date: | Re: [Amps] HT supply parts for GS35B in EU, Bill Turner |
|---|---|
| Next by Date: | [Amps] Regulated filament current, nemo zilch |
| Previous by Thread: | [Amps] HT supply parts for GS35B in EU, Conrad PA5Y |
| Next by Thread: | [Amps] Regulated filament current, nemo zilch |
| Indexes: | [Date] [Thread] [Top] [All Lists] |