Due to a re-assembly error/oversight (Diode too close to neighboring wire,
lesson re-learned) a diode and cap were damaged. I need to replace both.
The question is do I keep with the 1N5062 diode or go with something more
modern and replace them all?
Suggestions on replacement P/N?
https://www.dropbox.com/sh/13m1vyvftxadb3j/AADrWNE2INVEzlOvbdjcRU0Ba/MLA-250
0/MLA-2500%20PS%20Board%20Repair%20%2812%29.jpg
Ken
N4zed
_______________________________________________
Amps mailing list
Amps@contesting.com
http://lists.contesting.com/mailman/listinfo/amps
_______________________________________________
Amps mailing list
Amps@contesting.com
http://lists.contesting.com/mailman/listinfo/amps
|