Agreed Jim...
I tried a Google search for his exact relay and it turned up nothing.
There are quite a few Kilovac, and Jennings RJ1A s and HC1 s on EBay right
now. DO NOT use the HC3 relay.
Please make sure the relay you choose is a 26.5 volt coil which has 335 ohm
resistance, and the contacts are rated for RF. Not DC (like the HC3 is).
73
Jim W7RY
-----Original Message-----
From: Jim Garland
Sent: Sunday, April 07, 2013 11:04 AM
To: 'Louis Parascondola' ; amps@contesting.com
Subject: Re: [Amps] vacuum relay
I think the Gigavac K60C has been replaced by the more modern G60C. If it
has the same specs (roughly) as the G60C, it is not suitable for QSK. The
G60C relay is designed for switching DC or 60HZ loads up to 35A and 40KV. It
is quite slow (15mS make and break times). Best to find a relay intended for
RF switching with switching times in the 2-7 mS range
73,
Jim W8ZR
-----Original Message-----
From: Amps [mailto:amps-bounces@contesting.com] On Behalf Of Louis
Parascondola
Sent: Sunday, April 07, 2013 11:53 AM
To: amps@contesting.com
Subject: [Amps] vacuum relay
Hi, I have a Kilovac K60C381 relay 26v. Would this be good for QSK at a
KW using
W7RY system?
_______________________________________________
Amps mailing list
Amps@contesting.com
http://lists.contesting.com/mailman/listinfo/amps
_______________________________________________
Amps mailing list
Amps@contesting.com
http://lists.contesting.com/mailman/listinfo/amps
_______________________________________________
Amps mailing list
Amps@contesting.com
http://lists.contesting.com/mailman/listinfo/amps
|