Date: Sat, 3 Nov 2012 14:15:44 -0700 (PDT)
From: Douglas Johnson <w9iix1@yahoo.com>
To: AMPS <amps@contesting.com>
Subject: [Amps] plate voltage meter shunt
I am installing a meter to measure plate voltage 1-5000v@ 1a?dc, the meter
has a 1ma fs rating. ?the serial resistance I have made up in the past has
been 3 watt metal film resistors in series. since they can only rated for
200v per resistor it takes many to do the job. Can some other resistor
type with a higher rating?be used in a safe manner for this
purpose?...tnx, Doug,w9iix
## it’s a meter multiplier string..and not a shunt ! You can buy 1%
tol 3 kv rated resistors and also 1% tol 10 and 15 kv rated resistor’s...
from mouser. 5000/.001 = 5 megohms. Use 10 x 500K ohm resistors in
series.
I mount em on either perf board or drill out some micarta, plexiglass, or
UHMW. Just mount em so they go down one side,across, and back up the
other side. I mount the entire assy directly to the meter studs !
To pull that off, you need to make the board big enough. The usual deal
is to make it rectangular shaped, taller than wider, then whack two holes
for the meter studs towards the top of the board..with the rest of the
board hanging down.
## you can mount the board in a few diff configs. The idea is to keep
the 5 kv end well away from the meter itself. 5 kv enters resistor
#1...... and exits #10..then onto the positive of the meter. NEG of
meter goes DIRECTLY to the
B- end of the HV supply. Take is directly to the B- end of the HV caps
if you can at all possible. Don’t do some arrl fubar and run it to the
chassis.
## On my hb amps, I use a HV fuse in series with the 50 ohm glitch
resistor... in series with the B+. In those cases, I use one HV meter
in the HV supply, and a 2nd HV meter in the RF deck itself. If the HV
fuse blows open,
the HV meter in the HV supply will still read 5kv. The HV meter in the
RF deck will read ZERO. This is done for safety purposes. In some
cases, I will use a 3rd box, full of HC caps.... and that box also gets
it’s own HV neter.
later....... Jim VE7RF
Why the heck would anyone use 10 HV resistors? That would look like the mess
of 1/4W on a Harbach board that I always replace with three 5M Ohmites
anyway.
For 5KV and that meter 5 Ohmite Slim-Mox 1M 7.5KV resistors is all that is
needed. They are 1.25W rated and only $3.90 ea at Mouser. Mount on a
phenolic, and not perf board, and elevated on short phenolic, ceramic, or
other standoffs. The idea is to not have the resistor body on the phenolic
where years of HV will attract a possible conductive path. Perfboard is more
prone to moisture absorbtion but in a dry area its OK.
Carl
KM1H
_______________________________________________
Amps mailing list
Amps@contesting.com
http://lists.contesting.com/mailman/listinfo/amps
|